Each loft feature that you create requires at least one loft path. When you have defined the loft sections, you can choose to modify the loft path or paths. The paths of a loft feature connect a point on the starting section to a point on the ending section. If more than two loft sections are defined, each path also passes through a point on each intermediate section. You can define a loft path using the options on the Transition tabbed page of the Edit Loft dialog box.
When you create a loft feature, you can choose from the following methods to define a loft path:
Specify tangencies
Specify tangencies is the default loft path definition. If you select Specify tangencies, Abaqus/CAE creates a single smooth path that passes through the center of each loft section, as shown in Figure 11–51. You can apply tangency conditions that modify the shape of the loft near the starting and ending loft sections. For more information on loft tangency, see “Defining loft tangency,” Section 11.14.3.
Select path
If you choose Select path, you can select from existing edges to define a loft path. This method also allows you to define multiple loft paths. The loft feature is created by following the loft paths as they connect one loft section to the next, as shown in Figure 11–52. A loft feature with a single selected path behaves similarly to a swept feature except that the cross-section of the loft is constantly changing to match the position and shape of the next loft section along the path.
You must pick from existing line segments in the viewport to create paths connecting all of the loft sections. Each path must be a smooth curve, and it must connect the sections in the same order that they will be connected when the loft is created. You can use the 
tool to create spline wires that define the three-dimensional paths. For more information, see “Adding a point-to-point wire feature,” Section 11.23.2.
