Set this parameter equal to the name of the *AMPLITUDE option that gives the variation of the ambient temperature with time.

If this parameter is omitted in an Abaqus/Standard analysis, the reference magnitude is applied immediately at the beginning of the step or linearly over the step, depending on the value assigned to the AMPLITUDE parameter on the *STEP option (see “Defining an analysis,” Section 6.1.2 of the Abaqus Analysis User's Guide). If this parameter is omitted in an Abaqus/Explicit analysis, the reference magnitude is applied immediately at the beginning of the step.

Set OP=MOD (default) for existing *CRADIATE definitions to remain, with this option modifying existing radiation conditions or defining additional radiation conditions.

Set OP=NEW if all existing *CRADIATE definitions applied to the model should be removed.

This parameter applies only to Abaqus/Explicit analyses.

This parameter is relevant only for concentrated radiation conditions applied on the boundary of an adaptive mesh domain. If concentrated radiation conditions are applied to nodes in the interior of an adaptive mesh domain, these nodes will always follow the material.

Set REGION TYPE=LAGRANGIAN (default) to apply a concentrated radiation condition to a node that follows the material (nonadaptive).

Set REGION TYPE=SLIDING to apply a concentrated radiation condition to a node that can slide over the material. Mesh constraints are typically applied to the node to fix it spatially.

Set REGION TYPE=EULERIAN to apply a concentrated radiation condition to a node that can move independently of the material. This option is used only for boundary regions where the material can flow into or out of the adaptive mesh domain. Mesh constraints must be used normal to an Eulerian boundary region to allow material to flow through the region. If no mesh constraints are applied, an Eulerian boundary region will behave in the same way as a sliding boundary region.